Lantronix XPORT PROTM 900-560 - Manual (Page 51)

6: Line and Tunnel Settings
XPort Pro User Guide 51
Tunnel – Disconnect Mode
Relates to the disconnection of a specific tunnel. Disconnect Mode ends Accept Mode and
Connect Mode connections. When disconnecting, the XPort Pro shuts down the specific tunnel
connection gracefully.
The following settings end a specific tunnel connection:
 The XPort Pro receives the stop character.
 The timeout period has elapsed and no activity is going in or out of the XPort Pro. Both
Accept Mode and Connect Mode must be idle for the time frame.
 The XPort Pro observes the modem control inactive setting.
Note: To clear data out of the serial buffers upon a disconnect, enable “Flush Serial Data”.
To configure the Disconnect Mode for a specific tunnel:
1. Select Tunnel on the menu bar, if you are not already in the Tunnel web page.
2. Select a tunnel number at the top of the page.
3. Select Disconnect Mode. The specific tunnel Disconnect Mode page appears.
Figure 6-18 Tunnel 1 Disconnect Mode
4. Enter or modify the following settings:
Table 6-19 Tunnel Disconnect Mode
Tunnel – Disconnect
Mode Settings Description
Stop Character Enter the stop character in ASCII, hexadecimal, or decimal notation.
Select <None> to disable.