Lantronix XPORT PROTM 900-560 - Manual (Page 68)

9: Service Settings
XPort Pro User Guide 68
Note: The following section describes the steps to configure PPP 1 (PPP on serial line
1); these steps also apply to any line instance of the device.
To configure PPP:
1. Select PPP on the menu bar. The PPP web page appears.
2. Select a line number at the top of the page. The PPP Configuration page for the selected line
number appears.
Figure 9-2 PPP Configuration Settings
3. Enter or modify the following settings:
Table 9-3 PPP Configuration
4. Click Submit.
PPP Configuration Settings Description
Local IP Address Enter the IP address assigned to the device’s PPP interface.
Peer IP Address Enter the IP address assigned to the peer (when requested during
negotiation).
Authentication Mode Choose the authentication mode:
 None = no authentication is required
 PAP = Password Authentication Protocol
 CHAP = Challenge Handshake Authentication Protocol
 MS-CHAP = Microsoft Challenge-Handshake Authentication
Protocol
 MS-CHAPV2 = Microsoft Challenge-Handshake Authentication
Protocol Version 2
Username Enter a username if authentication is to be used on the PPP
interface. The peer must be configured to use the same username.
Password Enter a password if authentication is to be used on the PPP
interface. The peer must be configured to use the same password.