Planet Technology G.SHDSL.bis Bridge Router GRT-504 - Manual (Page 110)

GRT-504 4-Wire G.SHDSL.bis Firewall Router User’s Manual
7.3 Enable
To setup the router, move the cursor “ >>” to enable and press enter key. While the screen
appears, type the supervisor password. The default supervisor password is root. The password
will be prompted as “ * “ symbol for system security.
----------------------------------------------------------------------
Command: enable <CR>
Message: Please input the following information.
Supervisor password: ****
----------------------------------------------------------------------
In this sub menu, you can setup management features and upgrade software, backup the system
configuration and restore the system configuration via utility tools.
For any changes of configuration, you have to write the new configuration to NVRAM and reboot
the router to work with new setting.
The screen will prompt as follow.
>> enable
Modify command privilege
setup Configure system
status Show running system status
show View system configuration
write Update flash configuration
reboot Reset and boot system
ping Packet internet groper command
admin Setup management features
utility TFTP upgrade utility
exit Quit system
Command Description:
Command Description
enable Modify command privilege. When you login via serial console or Telnet, the
router defaults to a program execution (read-only) privileges to you. To change
the configuration and write changes to nonvolatile RAM (NVRAM), you must
work in enable mode.
setup To configure the router, you have to use the setup command.
status View the status of router.
show Show the system and configuration of router.
write Update flash configuration. After you have completed all necessary setting,
make sure to write the new configuration to NVRAM by “write” command and
reboot the system, or all of your changes will not take effect.
reboot Reset and boot system. After you have completed all necessary setting, make
sure to write the new configuration to NVRAM and reboot the system by
“reboot” command, or all of your changes will not take effect.
ping Internet ping command.
admin You can setup management features in this command.
utility Upgrade software and backup and restore configuration are working via “utility”
command.
exit Quit system
109