Planet Technology G.SHDSL.bis Bridge Router GRT-504 - Manual (Page 140)

GRT-504 4-Wire G.SHDSL.bis Firewall Router User’s Manual
The member ports are tagged members. Use PVID command to change the member port to
untagged members
To assign PVID (Port VID), move the cursor “>>” to PVID and press enter. The port index 1 to 4
represents LAN1 to LAN4 respectively and port index 5 to 12 represents WAN1 to WAN8. VID
value is the group at which you want to assign the PVID of the port. PVID is
----------------------------------------------------------------------
Command: setup vlan pvid <1~12> <1~4094>
Message: Please input the following information.
Port index <1~12>: 1
VID Value (Enter for default) <10>: 10
----------------------------------------------------------------------
To modify the link type of the port, move the cursor to link mode and press enter. There are two
types of link: access and trunk. Trunk link will send the tagged packet form the port and access link
will send un-tagged packet form the port. Port index 1 to 4 represents LAN1 to LAN4 respectively.
According to the operation mode of the device, link type of WAN port is automatically configured. If
the product operates in bridge mode, the WAN link type will be trunk, and in routing mode, access.
----------------------------------------------------------------------
Command: setup vlan link_mode <1~12> <Access|Trunk>
Message: Please input the following information.
Port index <1~12>: 1
Port link type (Tab select) <Trunk>: Access
----------------------------------------------------------------------
To view the VLAN table, move the cursor to list and press enter.
7.12.7 STP
Spanning-Tree Protocol (STP) is a link management protocol that provides path redundancy
while preventing undesirable loops in the network. For an Ethernet network to function
properly, only one active path can exist between two stations
The default is disable.
>> active
Trigger Bridge STP function
Once you enable the STP feature, you can see the STP status will follow IEEE 802.1d standard to
work. The working steps are Blocking, Listening, Learning and forwarding.
7.12.8 Route
You can setup the routing parameters in route command. If the product is configured as a bridge,
you do not want to setup the route parameters. Move the cursor “ >> “ to route and press enter.
>> static
Configure static routing table
Rip Configure RIP tool
If the Router is connected to more than one network, it may be necessary to set up a static route
between them. A static route is a pre-determined pathway that network information must travel to
reach a specific host or network.
139