Planet Technology G.SHDSL.bis Bridge Router GRT-504 - Manual (Page 26)

GRT-504 4-Wire G.SHDSL.bis Firewall Router User’s Manual
5 Configuration to the Router
This guide is designed to let users through Web Configuration or serial console with G.shdsl.bis
Router in the easiest and quickest way possible. Please follow the instructions carefully.
Note: There are three methods to configure the router: serial console, Telnet and Web Browser.
Only one configuration application is used to setup the Router at any given time. Users have
to choose one method to configure it.
For Web configuration, you can skip item 3.
For Serial Console Configuration, you can skip item 1 and 2.
5.1 Check List
(1) Check the Ethernet Adapter in PC or NB
Make sure that Ethernet Adapter had been installed in PC or NB used for configuration of the
router. TCP/IP protocol is necessary for web configuration, so please check the TCP/IP protocol
whether it has been installed.
(2) Check the Web Browser in PC or NB
According to the Web Configuration, the PC or NB need to install Web Browser, IE or Netscape.
Note: Suggest to use IE5.0, Netscape 6.0 or above and 800x600 resolutions or above.
(3) Check the Terminal Access Program
For Serial Console and Telnet Configuration, users need to setup the terminal access program
with VT100 terminal emulation.
(4) Determine Connection Setting
Users need to know the Internet Protocol supplied by your Service Provider and determine the
mode of setting.
Protocol Selection
RFC1483 Ethernet over ATM
RFC1577 Classical Internet Protocol over ATM
RFC2364 Point-to-Point Protocol over ATM
RFC2516 Point-to-Point Protocol over Ethernet
25