Planet Technology G.SHDSL.bis Bridge Router GRT-504 - Manual (Page 39)

GRT-504 4-Wire G.SHDSL.bis Firewall Router User’s Manual
Set up the DHCP Server parameters and fixed DHCP host table
Start IP Address: This field specifies the first of the contiguous addresses in the IP address pool.
End IP Address: The field specifies the last of the contiguous addresses in the IP address pool.
For example: If the LAN IP address is 192.168.0.1, the IP range of LAN is 192.168.0.2 to
192.168.0.51. The DHCP server assigns the IP form Start IP Address to End IP Address. The legal
IP address range is form 0 to 255, but 0 are reserved as network name and 255 are reserved for
broadcast. It implies the legal IP address range is from 1 to 254. That means you cannot assign an
IP greater than 254 or less then 1. Lease time 72 hours indicates that the DHCP server will
reassign IP information in every 72 hours.
DNS Server1, DNS Server2, and DNS Server3: Your ISP will provide at least one Domain Name
Service Server IP. You can type the router IP in this field. The router will act as DNS server relay
function. There have three DNS server can use.
You may assign a fixed IP address to some device while using DHCP, you have to put this device’s
MAC address in the Table of Fixed DHCP Host Entries. There have ten fixed IP address location
can use.
Every Ethernet device has a unique MAC (Media Access Control) address. The MAC address is
assigned at factory and consists of six pairs of hexadecimal characters, for example,
00:30:4F:0A:02:4F
Press Next to setup WAN1 parameters.
Some of the ISP provides DHCP server service by which the PC in LAN can access IP information
automatically. To setup the DHCP client mode, follow the procedure.
38