Planet Technology G.SHDSL.bis Bridge Router GRT-504 - Manual (Page 73)

GRT-504 4-Wire G.SHDSL.bis Firewall Router User’s Manual
Packet filter
Click Next can set up the packet filtering parameters.
If you want to configure the Packet Filtering Parameters, choose Enable and press Add.
It can setup the packet filter rule parameters:
Select the Protocol and configure the parameter.
Protocol: ANY, TCP, UDP, ICMP, GRE, RSVP, ESP and AH.(ANY means all protocol)
Direction: INBOUND (from WAN to LAN) or OUTBOUND (from LAN to WAN)
Action: DENY(block) or PERMIT(allow)
Description: Type a description for your customized service..
Src. IP Address: The source addresses or ranges of addresses to which this packet filter rule
applies. (Address 0.0.0.0 is equivalent Any)
Dest. IP Address: The destination addresses or ranges of addresses to which this packet filter rule
applies. (Address 0.0.0.0 is equivalent Any)
Schedule: Select everyday (always) or the day(s) of the week to apply the rule. Enter the start and
end times in the hour-minute format to apply the rule.
For example, If you want to ban all of the protocol from the IP (e.g.: 200.1.1.1) to access the all
PCs (e.g.: 192.168.0.2 ~ 192.168.0.50) in the LAN, key in the parameter as:
Protocol: ANY
Direction: INBOUND (INBOUND is from WAN)
Description: Hacker
Src. IP Address: 200.1.1.1
Dest. IP Address: 192.168.0.2-192.168.0.50
Schedule: You can set always or any time range which you want
72