Planet Technology G.SHDSL.bis Bridge Router GRT-504 - Manual (Page 139)

GRT-504 4-Wire G.SHDSL.bis Firewall Router User’s Manual
7.12.5 VLAN
Virtual LAN (VLAN) is defined as a group of devices on one or more LANs that are configured so
that they can communicate as if they were attached to the same wire, when in fact they are located
on a number of different LAN segments. Because VLAN is based on logical instead of physical
connections, it is extremely flexible.
You can setup the Virtual LAN (VLAN) parameters in vlan command. The router support the
implementation of VLAN-to-PVC only for bridge mode operation, i.e., the VLAN spreads over both
the COE and CPE sides. The unit supports up to 8 active VLANs with shared VLAN learning (SVL)
bridge out of 4096 possible VLANs specified in IEEE 802.1Q.
Move the cursor “ >> “ to vlan and press enter.
>> mode
Trigger virtual LAN function
modify Modify virtual LAN rule
pvid Modify port default VID
link_mode Modify port link type
List Show VLAN configuration
To active the VLAN function, move the cursor “ >> “ to mode and press enter. The products support
two types of VLAN, 802.11q and Port-Based. The IEEE 802.1Q defines the operation of VLAN
bridges that permit the definition, operation, and administration of VLAN topologies within a
bridged LAN infrastructure. Port-Based VLANs are VLANs where the packet forwarding decision is
based on the destination MAC address and its associated port.
7.12.6 802.11Q VLAN
Follow the following steps to configure 802.11q VLAN.
----------------------------------------------------------------------
Command: setup vlan active <Disable|8021Q|Port>
Message: Please input the following information.
Tigger VLAN function (Tab select) <Disable>: 8021Q
----------------------------------------------------------------------
To modify the VLAN rule, move the cursor “ >> “ to modify and press enter.
----------------------------------------------------------------------
Command: setup vlan modify <1~8> <1~4094> <string>
Message: Please input the following information.
Rule entry index <1~8>: 1
VLAN ID (ENTER for default) <1>: 10
VLAN port status (ENTER for default)<111111111111>:111111000000
----------------------------------------------------------------------
For each VLAN, VLAN ID is a unique number among 1~4095.
VLAN port status is a 12-digit binary number whose bit-1 location indicates the VLAN port
membership in which 4MSBs and 8MSB represents LAN ports and WAN port, respectively. For
example: the above setting means that the VID 20 member port includes LAN1, LAN2 and WAN.
138