Planet Technology G.SHDSL.bis Bridge Router GRT-504 - Manual (Page 141)

GRT-504 4-Wire G.SHDSL.bis Firewall Router User’s Manual
With Dynamic Routing, you can enable the Router to automatically adjust to physical changes in
the network’s layout. The Cable/DSL Firewall Router, using the RIP protocol, determines the
network packets’ route based on the fewest number of hops between the source and the
destination. The RIP protocol regularly broadcasts routing information to other routers on the
network.
You can setup 20 sets of static route in static command. After entering static menu, the screen will
show as follow:
>> add
Add static route entry
delete Delete static route entry
List Show static routing table
You can add 20 sets of static route entry by using add command. Type the IP information of the
static route including IP address, subnet mask and gateway.
You can delete the static route information via delete command.
You can review the static route entry by using list command.
To configure Routing Information Protocol (RIP), you can use rip command to setup the
parameters. Move the cursor “>>” to rip and press enter.
>> generic
Configure operation and auto summery mode
lan Configure LAN interface RIP parameters
wan Configure WAN interface RIP parameters
list Show RIP configuration
Generic command can setup RIP mode and auto summery mode.
If there are any routers in your LAN, you can configure LAN interface RIP parameters via lan
command.
The product supports 8 PVCs and you can configure the RIP parameters of each WAN via wan
command. Move the cursor “>>” to wan and press enter.
----------------------------------------------------------------------
Command: setup route rip wan <1~8> <more...>
Message: Please input the following information.
Active interface number <1~8>: 1
----------------------------------------------------------------------
The screen will prompt as follow:
>> attrib
Operation, authentication and Poison reverse mode
version RIP protocol version
authe Authentication code
Attrib command can configure RIP mode, authentication type and Poison reverse mode.
Version command can configure RIP protocol version.
140