NEC EXPRESS 320Lb-R - Manual (Page 282)

8-44 System Upgrade
1. Mount the N8804-001P1 100BASE-TX adapter to the slot with the same number in PCI
module #1 and #2, and then start the OS.
2. Build a dual LAN configuration.
For the setting procedure, see “Configure expanded LAN board” described later, or “Set
Dual LAN Card Configuration” in the separate volume of User’s Guide (Setup).
PCI Board Status LED Indications
LED
indications
Description Action
Green Duplex is specified,
however, the server
works in simplex
mode. Configure duplex.
Reapply the driver.
The PCI board is
properly installed and
operating in
non-duplex mode.
(Does not depend on
simplex or duplex
mode.) In non-duplex mode, no specific problem occurs.
The PCI board is
properly installed and
duplex is configured. The system is operating normally in duplex mode.
Off
The PCI board is not
installed yet, the PCI
board is installed
incorrectly, or the
power is not supplied. Mount the PCI board correctly.
If the PCI board was not mounted, there is no
problem.
Check the condition of power unit.
Remount the PCI module.
In the process of
configuring or
canceling the duplex
mode. Wait for a while until the indication changes. If the
indication does not change,
check the status of the
installed PCI board slot using NEC ESMPRO
Manager.
Red
Although the PCI
board is mounted, it is
offline or not
functioning. Make the installed PCI board slot online from NEC
ESMPRO Manager.
Mount the PCI board correctly.