Raymarine C Series - Manual (Page 162)

148 C-Series Display Reference Manual
Displaying vessel identity (AIS)
If you have an AIS receiver fitted to your system, you can use the AIS feature to:
• Display a target for any other AIS equipped vessels within a specified range of your
boat.
• Display voyage information being broadcasted by these targets i.e. their position,
course, speed and rate of turn.
• Display basic or detailed information for each target vessel including safety critical
target data.
• Set up a safe zone around your boat.
• View alarm and safety related messages.
This information is displayed in the form of an overlay or as a dialog box on your radar
screen. To overlay AIS on a radar window:
For more information on AIS, see Chapter 11:Automatic Identification System (AIS) .
6.11 Setting up your radar
The set up for your radar can be changed from the standard configuration to suit your
particular needs. Although you will probably only do this when you first use the radar,
you may decide to make subsequent adjustments once you become more familiar with
the system. Any settings that you change are retained and become the default settings
even when you power off.
To select the Radar Setup menus when a radar window is active:
D8435_1
CANCEL TARGET
To cancel an individual target:
MARPA LIST...
ID Bearing Range Course Speed CPA TCPA
2 187 0 T 4.0nm 130 0 T 1.5kt 4.0nm 8min
1 137 0 T 1.4nm 180 0 T 2.2kt 1.4nm 2min
Highlight target to be cancelled
CANCEL ALL
TARGETS
To cancel all targets:
OK
OK
D9024_1
PRESENTATION
AIS LAYER
ON
81221_4.book Page 148 Tuesday, February 28, 2006 5:24 PM