Raymarine C Series - Manual (Page 71)

Chapter 4: Using the Chart 57
Go to an existing waypoint
You can navigate to an existing waypoint by either selecting the appropriate waypoint
on-screen with the cursor or by selecting it from the waypoint list:
Note: For more information on navigating with Waypoints, please refer to Chapter
3:Working with Waypoints.
... selected with the cursor
This option navigates you to the waypoint that you select on screen.
... selected via the waypoint list
This option selects the waypoint that you wish to navigate to from the waypoint list.
:
Resetting cross track error (XTE)
When you are following a waypoint, you can restart the XTE. This results in a new
course from the current vessel position to the current target waypoint.
Restarting XTE is useful if you find yourself off track and want to go straight to your
target, rather than get back onto the original track.
Arriving at your target waypoint
When you arrive at the target (active) waypoint:
• An alarm sounds and
• A warning message is displayed.
GO TO WAYPOINT
D7461_2
WPT
Position cursor
over required
waypoint.
Dashed line from boat to
active (boxed) waypoint.
Navigation commences.
WPTS/
MOB
D6543-2
GOTO WAYPOINT
OPTIONS ...
GOTO WAYPOINT
GOTO
Or
Waypoint List
Select required
waypoint
81221_4.book Page 57 Tuesday, February 28, 2006 5:24 PM