5 where am i on the chart, 6 moving around the chart, Panning – Raymarine C Series User Manual
Page 60: Zooming in/out, Page 180
46
C-Series Display Reference Manual
4.5 Where am I on the chart?
Your current position is represented on screen by a boat symbol. If
neither heading nor COG data is available, the vessel is shown as a
solid circle.
If positional data has been selected for display (see
page 180
), your position will be
displayed in the data bar under VES POS.
Note:
For more information on waypoints, please refer to the Waypoint Chapter.
4.6 Moving around the chart
To move around the chart and display the area required at the appropriate scale, use a
combination of zooming and panning.
Note:
When you pan the chart, or when you change the scale in autorange mode; the
motion mode is suspended - see page 45 and page 85.
Panning
Panning moves the chart that is displayed to a different area. To pan a
chart, simply press the appropriate arrow (left/right, up/down) on the
trackpad. When the cursor reaches the edge of the screen, the chart pans.
Note:
When you pan the chart, active motion mode is suspended.
Zooming in/out
When you zoom in, the chart scale changes to show a smaller area in more
detail. Conversely, if you zoom out the chart area displayed is increased
but the detail is reduced.
Note:
The cartographic detail available on charts varies according to the chart and the
chart scale. Some areas provide detail at smaller scales than others.
D6627-1
Boat symbol
D8714_1
FIND
SHIP
Chart redraws with boat at centre
Toggle to FIND SHIP
If you cannot see your boat:
WPTS
MOB
OK
Accepts default
(or wait 3 seconds)
x2
To mark your current position:
D6583-3
D6585-2
D6585-1
RANGE
IN
OUT
81221_4.book Page 46 Tuesday, February 28, 2006 5:24 PM