Raymarine C Series - Manual (Page 49)

Chapter 3: Working with Waypoints 35
Changing waypoint details
When a waypoint is created it is assigned a default name, symbol and group. You can
change these details to suit your needs and add a comment if required. This is
particularly useful when you are managing large numbers of waypoints.
To change the details of a waypoint:
1. Select the detail you wish to edit:
2. Edit the selected detail:
Note: If you make a mistake whilst editing, press CANCEL.
Moving a waypoint
You can move any waypoint (except the active one) to a new position. There are two
methods of moving a waypoint:
... by entering new coordinates
If you know the new co-ordinates, bearing or range for the particular waypoint, you
can enter this information by editing the waypoint as described in the previous section.
... by dragging the waypoint to a new position
Note: To abandon the move, press CANCEL.
Edit Waypoint
D8286-1
WPT
Or
VIEW AND EDIT
DETAILS
Waypoint List
Select required waypoint with
cursor or via waypoint list
Highlight field
for changing
Edit Waypoint
EDIT SYMBOL
Edit details as required using:
To save
e.g.
To save and
exit editing
Soft key reflects
highlighted field
OK OK
Repeat for other fields, if necessary
, and/or Soft key
D8287-1
D8288-1
WPT
MOVE WAYPOINT PLACE WAYPOINT
Select waypoint
for moving Drag waypoint
to new location
WPT
WPT
81221_4.book Page 35 Tuesday, February 28, 2006 5:24 PM