TOA Electronics D-901 - Manual (Page 26)

26
8. INPUT-RELATED SETTINGS
The channel selected with the Input channel selector keys can be enabled or disabled using the Input channel
ON/OFF key.
To enable or disable individual functions, use the function ON/OFF key when each function is displayed.
8.1. Phantom Power ON/OFF Settings (Only with D-921E or D-921F module)
[ I N 1 ] P H A N T O M
O F F
ON
• Can be displayed and set only when MIC is selected on the PAD
setting screen (explained in the next section).
• Enable or disable phantom power using the function ON/OFF
key.
Note
Signals are muted for a specified period of time while changing
settings.
• Pressing the Input channel selector key for the channel in which
the D-921E or D-921F module is installed permits phantom
power setting for that channel. The [IN 1] indication changes to
the selected channel number indication.
• The setting screen reverts to the Input/Output Gain Setting
screen when the shift key is pressed.
8.2. PAD (Input Sensitivity) Settings (Only with D-921E or D-921F module)
[ I N 1 ] P A D
L I N E + 4 d B
PARAMETER
PUSH-ENTER
CHANGE
• Rotate the Setting knob to set the PAD (input sensitivity).
Parameter setting range: MIC: –50 or –36 dB
LINE: –10 or +4dB
Note
Signals are muted for a specified period of time while changing
settings.
• Pressing the Input channel selector key for the channel in which
the D-921E or D-921F module is installed permits PAD selection
for that channel. The [IN 1] indication changes to the selected
channel number indication.
• The setting screen reverts to the Input/Output Gain Setting
screen when the shift key is pressed.
Input trim gain settings
(p. 28)
8.3. Line Input Mode Selection (Only with D-936R module)
[ I N 1 ] L I N E I N
M I X A L L
PARAMETER
PUSH-ENTER
CHANGE
• Rotate the Setting knob to select the D-936R Stereo Input
Module operation mode.
• Either a single stereo input can be selected from among the 4
available stereo inputs (SELECT mode) or all 4 stereo channels
can be mixed (MIX ALL mode). Also, in MIX ALL mode, stereo
sources can be selected with the input selection screen. (Refer to
p. 28.)
Note
Signals are muted for a specified period of time while changing
settings.
• The setting screen reverts to the Input/Output Gain Setting
screen when the shift key is pressed.
Line (stereo) input
selection (p. 28)
(Only when the
PAD is set to
"MIC.")