TOA Electronics D-901 - Manual (Page 47)

47
9.4.1. Parametric equalizer
[ O U T 1 ] F I L T E R 1
T Y P E P E Q
PARAMETER
PUSH-ENTER
CHANGE
• Rotate the Setting knob to select PEQ and enter the Parametric
Equalizer setting screen.
• Pressing an Output channel selector key permits the filter to be
set for that channel. The [OUT 1] indication changes to the
selected channel number indication.
• The setting screen reverts to the Input/Output Gain Setting
screen when the shift key is pressed.
[Gain settings]
[ O U T 1 ] F I L T E R 1
G A I N + 0 . 0 d B
PARAMETER
PUSH-ENTER
CHANGE
• Rotate the Setting knob to set the gain.
Parameter setting range: –15 to +15 dB in 0.1 dB steps
• Pressing an Output channel selector key permits the filter to be
set for that channel. The [OUT 1] indication changes to the
selected channel number indication.
[Center frequency settings]
[ O U T 1 ] F I L T E R 1
F R E Q 1 . 0 0 k H z
PARAMETER
PUSH-ENTER
CHANGE
• Rotate the Setting knob to set the center frequency.
Parameter setting range: 20 Hz – 20 kHz in 1/24 octave steps
• Pressing an Output channel selector key permits the filter to be
set for that channel. The [OUT 1] indication changes to the
selected channel number indication.
[Q settings]
[ O U T 1 ] F I L T E R 1
Q 0 . 2 6 7
PARAMETER
PUSH-ENTER
CHANGE
• Rotate the Setting knob to set the Q.
Parameter setting range: 0.267 – 69.249 (96 points)
• Pressing an Output channel selector key permits the filter to be
set for that channel. The [OUT 1] indication changes to the
selected channel number indication.
9.4.2. High-pass filter
[ O U T 1 ] F I L T E R 1
T Y P E H P F - 6 d B
PARAMETER
PUSH-ENTER
CHANGE
• Rotate the Setting knob to select either HPF-6 dB or HPF-12 dB
and enter the High-Pass Filter setting screen.
The indications of 6 dB and 12 dB represent the slope: 6 dB/oct
and 12 dB/oct, respectively.
• Pressing an Output channel selector key permits the filter to be
set for that channel. The [OUT 1] indication changes to the
selected channel number indication.
• The setting screen reverts to the Input/Output Gain Setting
screen when the shift key is pressed.
[Cutoff frequency settings]
[ O U T 1 ] F I L T E R 1
F R E Q 1 . 0 0 k H z
PARAMETER
PUSH-ENTER
CHANGE
• Rotate the Setting knob to set the cutoff frequency.
Parameter setting range: 20 Hz – 20 kHz in 1/24 octave steps
• Pressing an Output channel selector key permits the filter to be
set for that channel. The [OUT 1] indication changes to the
selected channel number indication.