TOA Electronics D-901 - Manual (Page 42)

42
9. OUTPUT SETTINGS
Output channels selected with the Output channel selector keys can be enabled or disabled using the output
channel ON/OFF key. Use the function ON/OFF key to enable or disable each function displayed on the LCD
screen.
9.1. Output Channel Gain Settings
[ O U T 1 ] F A D E R
O N 0 . 0 d B ON
PARAMETER
PUSH-ENTER
CHANGE
• Rotate the Setting knob to set the output channel gain.
Parameter setting range: –INF (– ∞) to +10 dB
• Press the function ON/OFF key to enable or disable the
displayed channel.
• Pressing an Output channel selector key permits the gain to be
set for that channel. The [OUT 1] indication changes to the
selected channel number indication.
• The setting screen reverts to the Input/Output Gain Setting
screen when the shift key is pressed.
Filter settings (p. 45),
Output channel group
trim gain settings (next
section), or Crossover
settings (next page)
9.2. Output Channel Group Trim Gain Settings (Only when Group is set)
[ O U T 1 ] G R - T R I M
+ 0 . 0 d B
PARAMETER
PUSH-ENTER
CHANGE
• The indication at left is displayed only when Group setting is
performed. Perform the Group settings on the Utility setting
screen (p. 56).
• Rotate the Setting knob to set the group trim gain (offset gain).
Parameter setting range: –INF (– ∞) to +10 dB in 0.1 dB steps
• Pressing an Output channel selector key permits the group trim
gain to be set for that channel. The [OUT 1] indication changes to
the selected channel number indication.
• The setting screen reverts to the Input/Output Gain Setting
screen when the shift key is pressed.
Crossover settings
(next page) or
Filter settings (p. 45)