TOA Electronics D-901 - Manual (Page 57)

57
11. PRESET MEMORY SETTINGS
PRESET
The preset setting screen is displayed when the Preset key is pressed.
Pressing the key again exits the preset setting screen in any of the following settings, displaying the
Input/Output Gain Setting screen.
11.1. Preset Memory Save
Set parameters can be stored in memory (number of memories: 16).
[Parameters that can be stored in memory]
Input channel parameters: PAD, Phantom power, Line input mode selection, Line input selection, Input trim
gain, Input trim polarity, High-pass filter, Equalizer (low and high frequencies),
Compressor/auto-leveler mode selection, Compressor/auto-leveler, Level
sense, Gate, Auto-mixing group, Ducker, NOM attenuation ON/OFF, Input
channel gain, Channel ON/OFF, Group trim gain, and Bus assignment
Output channel parameters: Output channel gain, Group trim gain, Channel ON/OFF, Filters 1 – 6 (including
crossover), Compressor, and Delay
Microphone bus parameters: Feedback suppression (Dynamic mode ON/OFF, Filter number, and Filter
parameters set in Auto and Dynamic modes), Echo, and Bus assignment
Others: Stereo link, Group, Crossover configuration, NOM attenuation, and Channel
selection status
[ P R E S E T ] S A V E
N o . 1 O K ?
Step 1. Press the and shift keys to select the desired preset memory
number.
Preset memory recall
(next page)
[ P R E S E T ] S A V E
N o . 1 O K ?
[ P R E S E T ] S A V E
N o . 2 O K ?
[ P R E S E T ] S A V E
N o . 1 6 O K ?
Preset memory
number 1 selection Preset memory
number 2 selection Preset memory
number 16 selection
Step 2. Press the Setting knob to execute the function.
The indication "Now Saving..." is displayed and saving begins.
Saving is completed when the indication turns off.
[ P R E S E T ]
N o w S a v i n g . . .
PARAMETER
PUSH-ENTER
CHANGE
Note: To cancel the function, press the Preset key.