TOA Electronics D-901 - Manual (Page 3)

3
8.6.2. Input trim polarity settings ...................................................................... 28
8.7. High-Pass Filter Settings
8.7.1. Cutoff frequency settings ....................................................................... 29
8.7.2. Q settings ............................................................................................... 29
8.8. Equalizer Settings
8.8.1. Gain settings .......................................................................................... 30
8.8.2. Center frequency settings ...................................................................... 30
8.8.3. Q settings ............................................................................................... 30
8.9. Compressor/Auto-Leveler Mode Selection ...................................................... 31
8.10. Compressor Settings
(only when the compressor mode is selected in Section 8.9.)
8.10.1. Threshold level settings ....................................................................... 31
8.10.2. Ratio settings ....................................................................................... 32
8.10.3. Attack time settings .............................................................................. 32
8.10.4. Release time settings ........................................................................... 32
8.10.5. Makeup gain settings ........................................................................... 32
8.11. Auto-Leveler Settings
(only when the auto-leveler mode is selected in Section 8.9.)
8.11.1. Target level settings ............................................................................. 33
8.11.2. Maximum gain settings ........................................................................ 33
8.11.3. Attack time settings .............................................................................. 33
8.11.4. Release time settings ........................................................................... 34
8.12. Level Sense Settings
8.12.1. Attack time settings .............................................................................. 34
8.12.2. Release time settings ........................................................................... 34
8.13. Gate Settings
8.13.1. Threshold level settings ....................................................................... 35
8.13.2. Hysteresis settings ............................................................................... 35
8.13.3. Depth settings ...................................................................................... 35
8.13.4. Hold time settings ................................................................................ 35
8.13.5. Attack time settings .............................................................................. 35
8.13.6. Release time settings ........................................................................... 35
8.14. Auto-Mixing Group Settings ............................................................................. 37
8.15. Ducker Settings
8.15.1. Priority settings .................................................................................... 38
8.15.2. Attenuation settings ............................................................................. 38
8.15.3. Attack time settings .............................................................................. 39
8.15.4. Release time settings ........................................................................... 39
8.16. NOM Attenuation ON/OFF Settings ................................................................. 39
8.17. Input Channel Gain Settings ............................................................................ 40
8.18. Input Channel Group Trim Gain Settings (Only when Group is set) ................ 40
8.19. Bus Assignment and Crosspoint Gain Settings
8.19.1. Bus assignment settings ...................................................................... 41
8.19.2. Crosspoint gain settings ....................................................................... 41
9. OUTPUT SETTINGS
9.1. Output Channel Gain Settings ......................................................................... 42
9.2. Output Channel Group Trim Gain Settings (Only when Group is set) ............. 42
9.3. Crossover Settings (Only when Crossover function is enabled)
9.3.1. Slope settings ........................................................................................ 43
9.3.2. Cutoff frequency settings ....................................................................... 44
9.3.3. Q settings ............................................................................................... 44
9.3.4. Q2 settings ............................................................................................. 44
9.3.5. Crossover gain settings ......................................................................... 44
9.3.6. Crossover filter polarity settings ............................................................. 44
9.4. Filter Settings ................................................................................................... 45