TRENDnet TEG-S3000I - Manual (Page 112)

110
802.1X
When enabling the IEEE 802.1X function, you can configure the parameters of this
function.
System Configuration
1. Radius Server IP: set the Radius Server IP address.
2. Server Port: set the UDP destination port for authentication requests to the
specified Radius Server.
3. Accounting Port: set the UDP destination port for accounting requests to the
specified Radius Server.
4. Shared Key: set an encryption key for use during authentication sessions with the
specified radius server. This key must match the encryption key used on the Radius
Server.
5. NAS, Identifier: set the identifier for the radius client.
6. Click Apply .
802.1x Configuration – System Configuration interface
Per port Configuration
1. Select the port in Port column.
2. Select the state of port. There are four states: