TRENDnet TEG-S3000I - Manual (Page 89)

87
Console Port Information
Console is a standard UART interface to communicate with Serial Port. User can use
windows HyperTerminal program to link the switch. Please refer to Console
Management Æ Console login for detail steps.
Console port information shows as follow:
Bits per seconds: 9600
Data bits: 8
Parity: none
Stop Bits: 1
Flow control: none
Console Port Information interface
Port Controls
You can change the port status.
1. Select the port by scroll the list in Port column.
2. State: User can disable or enable this port control.
3. Negotiation: User can set auto negotiation mode is Auto, Nway (specify the
speed/duplex on this port and enable auto-negotiation), Force of the port.
4. Speed: set the speed of each port.
5. Duplex: set full-duplex or half-duplex mode of the port.
6. Flows control: set flow control function is ON or OFF in Full Duplex mode.
7. Back Pressure: set Back Pressure is ON or OFF in Half Duplex mode.
8. Band Width: The port1 ~ port 24, supports port ingress and egress rate control.
For example, assume port 1 is 10Mbps, users can set it’s effective egress rate is