TRENDnet TEG-S3000I - Manual (Page 37)

35
6. Select <Save> to save the configuration.
NOTE: If you had configured the trunk groups, you can see it (ex: Trunk1, Trunk2…)
in the port list. You also can configure the trunk group as the VLAN member.
Create VLAN Group: PortBase interface
„ Create 802.1Q VLAN
1. Enable security VLAN setting: select to enable or disable security VLAN group.
When you select to enable security VLAN group, only the members in this VLAN
group can access to the switch. The steps of setting security VLAN refer to the
following step 2~ 8. After you have configured the security VLAN group, you can
continue to create other VLAN groups. When you don’t select to configure security
VLAN group, then just create VLAN group refer to following step 2 ~ 8.
Note: There is only one security VLAN group.