Rear panel, Desktop installation – TRENDnet TEG-S3000I User Manual
Page 14
12
Off
Power is not connected
Green
The port is connecting with the device.
Blinks
The port is receiving or transmitting data.
LNK/ACT
Off
No device attached.
Orange
The port is operating in Full-duplex mode.
Blinks
Collision of Packets occurs in the port.
FDX/COL
Off
In half-duplex mode
Table 2-1. The Description of LED Indicators
Rear Panel
A module slot, 3-pronged power plug, 2 fans, a power switch button, and a console port
are located at the rear Panel of the TEG-S3000i chassis switch as shown in Figure 2-1.
The Switch will work with AC power in the range of 100-240V AC, 50-60Hz.
Figure 2-1. The Rear Panel
of the TEG-S3000i chassis switch
Desktop Installation
Set the Switch on a sufficiently large flat space with a power outlet nearby. The surface
where you put your Switch should be clean, smooth, level and sturdy. Make sure there
is enough clearance around the Switch to allow attachment of cables, power cord and
air circulation.