Moulinex HV10 ME850 - Manual (Page 19)

13
• For your safety, this appliance complies with applicable standards and
regulations:
- Low Voltage Directive
- Electromagnetic Compatibility
- Environment
- Materials in contact with food
BEFORE FIRST USE
Wash all accessories in soapy water. Rinse, and carefully dry them
straight away.
The screen and the cutter need to be kept oiled. Coat them with oil.
Do not use your appliance empty, if the screens are not oiled.
USING YOUR APPLIANCE FOR THE FIRST TIME
MINCER HEAD (A):
Assembling the mincer head (diagrams 1.1 and 1.2)
Take the body A1 by the feed tube, holding the wider opening
uppermost. Then insert the feed screw A2 (long shaft first) into the body
A1.
Fit the stainless steel cutter A3 onto the short shaft that protrudes from
the feed screw A2 with the cutting edges facing outside. Fit the chosen
screen on the cutter A3, locating the lug in the notch on the body A1.
Screw the nut A5 home (without locking it).
Fitting the mincer head onto the appliance (diagram 2):
Facing the motor unit H which should be disconnected, insert the mincer
head with the feed tube inclined to the right. Line up the two pins of the
mincer head with the two notches on the motor unit.
Push the mincer head fully into the motor unit H and then turn the feed
tube to the left until it comes to a stop (the feed tube should be vertical
at this point).
Engage the removable tray B onto the mincer head feed tube. Plug in
the appliance; it is ready for use.
2643245 Hachoir HV10_Mise en page 1 21/07/11 14:21 Page13