Yamaha Professional Audio Workstation AW4416 - Manual (Page 118)

Chapter5—Recording on the AW4416
— Operation Guide
103
2. Play back the song from the beginning, and watch the L/R level meter in
the level meters/counter section.
If the red 0 dB segment lights, lower faders 1–16 and/or the STEREO fader.
3. After you have set the level, rewind the song to the beginning. Then
hold down the Transport section [REC] (●) key and press the [PLAY] key
(®).
Recording on the stereo track will begin.
In order to create an audio CD (44.1 kHz), there must be at least four seconds of
data in the stereo track.
4. When you are finished recording, press the [STOP] (■) key.
5. To listen to the newly recorded stereo track, press the Recorder section
[TRACK] key → [F3] key.
The TRACK screen Stereo page will appear, allowing you to play back or erase
the stereo track. When the AW4416 is in the initial state, the M (mute) button in
the upper left of the screen will be turned on, muting the stereo track.
6. Move the cursor to the M (mute) button and press the [ENTER] key.
Muting of the stereo track will be defeated, allowing the stereo track to play back.
At this time, the stereo track will automatically be assigned to monitor channels
1/2, and the remaining monitor channels will be muted. If you play back the song
in this state, the stereo track can be monitored via monitor channels 1/2 → stereo
bus.
8 9 13 14 15 16 10 11 12
–dB 0
2
6
20
30
42
60
10
14
18
20
26
12
FINE
READY
INPUT
L R
S F ms
EXT VARI
44.1k 48k LOCK
WORD CLOCK MTC SCENE
SLAVE
MASTER
INT E
1 2 3 4 5 6 7
–dB 0
2
6
20
30
42
60
10
14
18
20
26
12
FINE
READY
INPUT
REMAIN
ABS
REL
H M
–dB 0
2
6
20
30
42
60
10
14
18
20
26
12
FINE
READY
INPUT
L R
E
L/R level meter