Yamaha Professional Audio Workstation AW4416 - Manual (Page 151)

Chapter8—Patching
136
— Operation Guide
Patching to the outputs
When the AW4416 is in the default state, the following signals are assigned to the
OMNI OUT jacks, STEREO OUT jacks, and digital I/O card outputs. If necessary,
you can change the output signals that are assigned to these output jacks.
Here’s how to assign the desired signal to each output jack.
1. Press the [SETUP] key → [F2] (Patch OUT) key.
The display will show the SETUP screen Patch OUT page. The various fields of
the display will show the patched status of each output jack.
Tip!
If the Patch OUT tab is not assigned to the [F2] key, press the [SHIFT] key + [F1] key
to switch the tabs, and then press the [F2] key.
1 OMNI OUT jack 1–4
B DIGITAL STEREO OUT jack
C STEREO OUT jack
D OUTPUT 1–8 of an I/O card (slot 1)
E OUTPUT 1–8 of an I/O card (slot 2)
AUX buses 1–4
Stereo output channel
Buses 1–8
OMNI OUT jacks 1–4
DIGITAL STEREO OUT jack
STEREO OUT jacks
Mixer section
Output
patch
Ч 8
Ч
2
Ч 2
Ч 4
Ч 8
OPTION I/O
slot 1
OPTION I/O
slot 2
I/O
card
I/O
card
1
2 3
4
5