Yamaha Professional Audio Workstation AW4416 - Manual (Page 481)

Tutorial—Load the Demo Song
8
— Tutorial
Load the Demo Song
Before you can work on the demo song, you’ll first need to load it onto the
AW4416 hard disk from the supplied CD-ROM.
This tutorial assumes that you already have a CD-RW drive configured for use
with your AW4416. See the Operation Guide for information on installing and
connecting an external CD-RW drive.
Load the Demo Song From the CD-ROM
Onto the AW4416 Hard Disk
1. Press the AW4416 [FILE] key.
2. Press the [F2] function key to go to the “Restore” page.
3. Make sure that the SCSI ID number of your CD-RW drive is selected in the
SOURCE DRIVE window (if it isn’t, move the cursor to the SOURCE DRIVE
window and use the DATA dial to select the appropriate SCSI ID number,
then press the [ENTER] key). The default SCSI drive number is SCSI#3. If
you install a CD-RW drive manufactured by Yamaha, the SCSI ID will be set
to “3” at the factory, and we recommend that you leave it at this setting.
4. Open the CD-tray by pressing the [F2] function key (“CD UNLOAD”) while
holding the [SHIFT] key. Place the demo CD-ROM on the tray (label side
up) and press the [F1] function key (“CD LOAD”) while holding the [SHIFT]
key to close the tray and load the CD.
5. The demo song “So Fine” should appear in the list on the display.
Move the cursor to the RESTORE SONG window, and then use the [ENTER]
key to switch the DISABLE button to ENABLE.
6. Move the cursor to “EXECUTE” on the display, then press the [ENTER] key.
When the “ARE YOU SURE?” confirmation prompt appears, move the cur-
sor to “OK” and press [ENTER] to begin the restore operation.
7. When the “COMPLETE” window appears, the restore operation has fin-
ished.
It take about 10 minutes to restore the demo song. Once the restore pro-
cess has begun, it cannot be stopped.