Yamaha Professional Audio Workstation AW4416 - Manual (Page 489)

Tutorial—Mixdown
16
— Tutorial
❒ Track 3: Claves/Electronic Drums
This track needs a bit of compression to make the electronic drums jump out of
the mix when they appear at the outro. Later, when we work on the automation,
we’ll boost this track a bit at the outro for extra impact.
1. Press the track 3 [SEL] key to select the claves/electronic drums track.
2. Press the MIXER [DYN] key to access the dynamics parameters.
3. The “COMP” dynamics type should already be selected (it’s the default).
Move the cursor to the “ON/OFF” parameter and turn dynamics for the
selected track “ON”.
4. Use the cursor keys and data dial to make the following dynamics settings
for the claves/electronic drums track:
❒ Track 4: Bass
The bass track is a bit “flabby” and lacks punch. We’ll use EQ to tighten the
sound up a little, and compression to give the track a little more uniformity and
power.
1. Press the track 4 [SEL] key to select the bass track.
2. Press the MIXER [EQ] key.
3. Make sure that the EQ for the selected track is ON.
4. Use the cursor keys and data dial or the virtual EQ controls to make the fol-
lowing EQ settings for the bass track:
5. Press the MIXER [DYN] key to access the dynamics parameters.
6. The “COMP” dynamics type should already be selected. Move the cursor to
the “ON/OFF” parameter and turn dynamics for the selected track “ON”.
7. Use the cursor keys and data dial to make the following dynamics settings
for the bass track:
THRESH. RATIO OUT GAIN ATTACK RELEASE KNEE
–24 10:1 0.0 29 6 hard
LOW L-MID H-MID HIGH
Q 6.3 7 8 —
F 66.0 223 4.75 kHz —
G +2.5 –4.5 +6.0 —
THRESH. RATIO OUT GAIN ATTACK RELEASE KNEE
–15 8:1 +2.0 51 192 2