ZyXEL Communications GS-2724 - Manual (Page 196)

Chapter 29 Access Control
GS-2724 User’s Guide
196
Figure 98 SNMP
The following table describes the labels in this screen.
29.3.4 Setting Up Login Accounts
Up to five people (one administrator and four non-administrators) may access the Switch via
web configurator at any one time.
• An administrator is someone who can both view and configure changes. The username for
the Administrator is always admin. The default administrator password is 1234.
"
It is highly recommended that you change the default administrator password
(1234).
• A non-administrator (username is something other than admin) is someone who can view
but not configure settings.
Table 70 SNMP
LABEL DESCRIPTION
Get Community Enter the get community, which is the password for the incoming Get- and GetNext-
requests from the management station.
Set Community Enter the set community, which is the password for incoming Set- requests from the
management station.
Trap Community Enter the trap community, which is the password sent with each trap to the SNMP
manager.
Trap Destination Enter the IP addresses of up to four stations to send your SNMP traps to.
Apply Click Apply to save your changes to the Switch’s run-time memory. The Switch
loses these changes if it is turned off or loses power, so use the Save link on the top
navigation panel to save your changes to the non-volatile memory when you are
done configuring.
Cancel Click Cancel to reset the fields.