ZyXEL Communications GS-2724 - Manual (Page 286)

Chapter 41 Interface Commands
GS-2724 User’s Guide
286
• Set the outgoing traffic ports as the CPU (0), seven (7) and eight (8).
41.2.11 qos priority
Syntax:
qos priority <0 .. 7>
where
An example is shown next.
• Enable ports one, three, four and five for configuration.
• Set the IEEE 802.1p quality of service priority as four (4).
41.2.12 name
Syntax:
name <port-name-string>
where
An example is shown next.
• Enable port one for configuration.
• Set a name for the port.
41.2.13 speed-duplex
Syntax:
speed-duplex <auto|10-half|10-full|100-half|100-full|1000-full>
sysname(config)# vlan-type port-based
sysname(config)# interface port-channel 1,3-5
sysname(config-interface)# egress set 0,7,8
<0 .. 7> = Sets the quality of service priority for a port.
sysname(config)# interface port-channel 1,3-5
sysname(config-interface)# qos priority 4
<port-name-string> = Sets a name for your port interface.
sysname(config)# interface port-channel 1
sysname(config-interface)# name Test