ZyXEL Communications GS-2724 - Manual (Page 53)

Chapter 4 The Web Configurator
GS-2724 User’s Guide
53
VLAN This link takes you to screens where you can configure port-based or 802.1Q VLAN
(depending on what you configured in the Switch Setup menu).
Static MAC
Forwarding
This link takes you to screens where you can configure static MAC addresses for a
port. These static MAC addresses do not age out.
Filtering This link takes you to a screen to set up filtering rules.
Spanning Tree
Protocol
This link takes you to screens where you can configure the RSTP/MRSTP to
prevent network loops.
Bandwidth
Control
This link takes you to screens where you can cap the maximum bandwidth allowed
from specified source(s) to specified destination(s).
Broadcast Storm
Control
This link takes you to a screen to set up broadcast filters.
Mirroring This link takes you to screens where you can copy traffic from one port or ports to
another port in order that you can examine the traffic from the first port without
interference
Link Aggregation This link takes you to a screen where you can logically aggregate physical links to
form one logical, higher-bandwidth link.
Port
Authentication
This link takes you to a screen where you can configure RADIUS (Remote
Authentication Dial-In User Service), a protocol for user authentication that allows
you to use an external server to validate an unlimited number of users.
Port Security This link takes you to a screen where you can activate MAC address learning and
set the maximum number of MAC addresses to learn on a port.
Classifier This link takes you to a screen where you can configure the Switch to group
packets based on the specified criteria.
Policy Rule This link takes you to a screen where you can configure the Switch to perform
special treatment on the grouped packets.
Queuing Method This link takes you to a screen where you can configure queuing with associated
queue weights for each port.
VLAN Stacking This link takes you to a screen where you can configure VLAN stacking.
Multicast This link takes you to a screen where you can configure various multicast features
and create multicast VLANs.
IP Application
Static Routing This link takes you to screens where you can configure static routes. A static route
defines how the Switch should forward traffic by configuring the TCP/IP parameters
manually.
RIP This link takes you to a screen where you can configure the RIP (Routing
Information Protocol) direction and versions.
IGMP This link takes you to a screen where you can configure the IGMP settings.
DiffServ This link takes you to screens where you can enable DiffServ, configure marking
rules and set DSCP-to-IEEE802.1p mappings.
DHCP This link takes you to a screen where you can configure the DHCP settings.
Management
Maintenance This link takes you to screens where you can perform firmware and configuration
file maintenance as well as reboot the system.
Access Control This link takes you to screens where you can change the system login password
and configure SNMP and remote management.
Diagnostic This link takes you to screens where you can view system logs and test port(s).
Table 5 Navigation Panel Links (continued)
LINK DESCRIPTION