5 interface route-domain commands, Table 92 interface route-domain commands, Section – ZyXEL Communications GS-2724 User Manual
Page 258
Chapter 38 Introducing Commands
GS-2724 User’s Guide
258
38.11.5 interface route-domain Commands
The following table lists the
interface route-domain
commands in configuration mode.
Use these commands to configure the IP routing domains.
speed-duplex <auto|10-half|10-
full|100-
half|100-
full|1000-full>
Sets the duplex mode (
half
or
full
) and speed (
10
,
100
or
1000
Mbps) of the connection on
the interface. Selecting
auto
(auto-negotiation) makes one port
able to negotiate with a peer
automatically to obtain the
connection speed and duplex
mode that both ends support.
13
spq
Sets the port(s) to use Strict
Priority Queuing.
13
vlan-stacking priority
<0-7>
Sets the priority of the specified
port(s) in VLAN stacking.
13
role <access |
tunnel>
Sets the VLAN stacking port roles
of the specified port(s).
13
SPVID <vlan-id>
Sets the service provider VID of
the specified port(s).
13
vlan-trunking
Enables VLAN Trunking on ports
connected to other switches or
routers (but not ports directly
connected to end users) to allow
frames belonging to unknown
VLAN groups to pass through the
Switch.
13
weight <wt1>
<wt2> ... <wt8>
A weight value of one to eight is
given to each variable from wt 1 to
wt 8.
13
wrr
Sets the port(s) to use Weighted
Round Robin queuing.
13
Table 91 interface port-channel Commands (continued)
COMMAND
DESCRIPTION
PRIVILEG
E
Table 92 interface route-domain Commands
COMMAND
DESCRIPTION
PRIVILEG
E
interface
route-domain
<ip-address>/
<mask-bits>
Enables a routing domain for
configuration.
13
exit
Exits from the interface routing-
domain command mode.
13
ip
igmp <v1|v2>
Enables IGMP in this routing
domain.
13
igmp robustness-
variable <2-255>
Sets the igmp robustness
variable on the Switch. This
variable specifies how
susceptible the subnet is to lost
packets.
13