4 interface port-channel commands, Table 91 interface port-channel commands, Section – ZyXEL Communications GS-2724 User Manual
Page 255
Chapter 38 Introducing Commands
GS-2724 User’s Guide
255
38.11.4 interface port-channel Commands
The following table lists the
interface port-channel
commands in configuration mode.
Use these commands to configure the ports.
Table 91 interface port-channel Commands
COMMAND
DESCRIPTION
PRIVILEG
E
interface
port-
channel
<port-
list>
Enables a port or a list of ports for
configuration.
13
bandwidth-limit
Enables ingress (pir), cir and
egress limits on the port(s).
13
cir
Enables the guaranteed
bandwidth limits for incoming
traffic on the port(s).
13
cir <Kbps>
Sets the guaranteed bandwidth
allowed for incoming traffic on the
port(s).
13
pir
Enables bandwidth limits allowed
for incoming traffic on the port(s).
13
pir <Kbps>
Sets the maximum bandwidth
allowed for incoming traffic on the
port(s).
13
egress
Enables bandwidth limits allowed
for outgoing traffic on the port(s).
13
egress <Kbps>
Sets the maximum bandwidth
allowed for outgoing traffic on the
port(s).
13
bpdu-control
<peer|tunnel|disc
ard|network>
Sets how Bridge Protocol Data
Units (BPDUs) are used in STP
port states.
13
broadcast-limit
Enables broadcast storm control
limit on the port(s).
13
<pkt/s>
Specifies the maximum number of
broadcast packets to allow
through the port.
13
diffserv
Enables DiffServ on the port(s).
13
dlf-limit
Enables the Destination Lookup
Failure (DLF) limit.
13
<pkt/s>
Sets the interface DLF limit in
packets per second (pps).
13
egress set <port-
list>
Sets the outgoing traffic port list
for a port-based VLAN.
13
exit
Exits from the interface port-
channel command mode.
13
flow-control
Enables interface flow control.
Flow control regulates
transmissions to match the
bandwidth of the receiving port.
13