Multicast vlan registration commands, 1 overview, 2 create multicast vlan – ZyXEL Communications GS-2724 User Manual
Page 297: Chapter 43 multicast vlan registration commands, 1 overview 43.2 create multicast vlan, Multicast vlan registration commands (297)
GS-2724 User’s Guide
297
C
H A P T E R
43
Multicast VLAN Registration
Commands
This chapter shows you how to use Multicast VLAN Registration (mvr) commands.
43.1 Overview
Use the mvr commands in the configuration mode to create and configure multicast VLANs.
"
If you want to enable IGMP snooping see
.
43.2 Create Multicast VLAN
Use the following commands in the config-mvr mode to configure a multicast VLAN group.
Syntax:
mvr <vlan-id>
mvr <vlan-id> source-port <port-list>
mvr <vlan-id> receiver-port <port-list>
mvr <vlan-id> inactive
mvr <vlan-id> mode <dynamic|compatible>
mvr <vlan-id> name <name-str>
mvr <vlan-id> tagged <port-list>
mvr <vlan-id> group <name-str> start-address <ip> end-address <ip>
mvr <vlan-id> exit
where
<vlan-id>
=
The VLAN ID [1 – 4094].
source-port
<port-list>
=
Specifies the MVR source ports which send and receive multicast
traffic.
receiver-port
<port-list>
=
Specifies the MVR receiving ports which only receive multicast
traffic.
name <name-str>
=
A name to identify the multicast VLAN group.