ZyXEL Communications GS-2724 User Manual
Page 56
Chapter 4 The Web Configurator
GS-2724 User’s Guide
56
1 Connect to the console port using a computer with terminal emulation software. See
for details.
2 Disconnect and reconnect the Switch’s power to begin a session. When you reconnect
the Switch’s power, you will see the initial screen.
3 When you see the message “
Press any key to enter Debug Mode within 3
seconds ...
” press any key to enter debug mode.
4 Type
atlc
after the “
Enter Debug Mode
” message.
5 Wait for the “
Starting XMODEM upload
” message before activating XMODEM
upload on your terminal.
6 After a configuration file upload, type
atgo
to restart the Switch.
Figure 18 Resetting the Switch: Via the Console Port
The Switch is now reinitialized with a default configuration file including the default
password of “1234”.
Bootbase Version: V3.1 | 03/08/2007 18:22:24
RAM:Size = 64 Mbytes
DRAM POST: Testing: 65536K OK
DRAM Test SUCCESS !
FLASH: Intel 64M
ZyNOS Version: V3.70(AYC.0)b0 | 03/08/2007 14:39:15
Press any key to enter debug mode within 3 seconds.
............................................................
(Compressed)
Version: GS-2724, start: 500e9030
Length: A37326, Checksum: 2411
Compressed Length: 22F7C8, Checksum: CA3C
Copyright (c) 1994 - 2006 ZyXEL Communications Corp.
initialize mgmt, ethernet address: 00:19:cb:00:11:f9
initialize switch, ethernet address: 00:19:cb:00:11:fa
Initializing switch unit 0...
Initializing switch unit 1...
Initializing VLAN Database...
Initializing IP Interface...
Initializing Advanced Applications...
Initializing Command Line Interface...
Initializing Web Interface...
Press ENTER to continue...