ZyXEL Communications GS-2724 - Manual (Page 257)

Chapter 38 Introducing Commands
GS-2724 User’s Guide
257
no bandwidth-limit Disables bandwidth limit on the
port(s).
13
bandwidth-limit
<cir> Disables cir bandwidth limits on
the port(s).
13
bandwidth-limit
<pir> Disables pir bandwidth limits on
the port(s).
13
bandwidth-limit
<egress> Disables egress bandwidth limits
on the port(s).
13
broadcast-limit Disables broadcast storm control
limit on the port(s).
13
diffserv Disables DiffServ on the port(s). 13
dlf-limit Disables destination lookup failure
(DLF) on the Switch.
13
egress-set <port-
list> Disables the egress port setting. 13
flow-control Disables flow control on the
port(s).
13
ge-spq Disables strict priority queuing on
the Gigabit ports.
13
gvrp Disable GVRP on the port(s). 13
igmp-filtering
profile Disables IGMP filtering. 13
igmp-group-limit Disables IGMP group limitation. 13
igmp-immediate-
leave Disables the IGMP immidiate
leave function.
13
inactive Enables the port(s) on the Switch. 13
ingress-check Disables ingress checking on the
port(s).
13
intrusion-lock Disables intrusion-lock on a port
so that a port can be connected
again after you disconnected the
cable.
13
mirror Disables port mirroring on the
port(s).
13
multicast-limit Disables multicast limit on the
port(s).
13
vlan-trunking Disables VLAN trunking on the
port(s).
13
pvid <vlan-id> The default PVID is VLAN 1 for all
ports. Sets a PVID in the range 1
to 4094 for the specified interface.
13
qos priority <0 .. 7> Sets the quality of service priority
for an interface.
13
Table 91 interface port-channel Commands (continued)
COMMAND DESCRIPTION
PRIVILEG
E