Accusys ExaSAN SW-08 - Manual (Page 16)

1. Introduction
User Guide Page 1-7
4. Room to Grow
• Scales up with the simple additions of RAID, low-cost switch, HBAs, and cables
5. Highly affordable
• Serial architecture and components reduce the cost of workgroup storage by 40 percent compared
to conventional FC SANs
1.2 Unpacking the System
Your ExaSAN Compact system is shipped in special packaging to provide protection during
transportation, as well as to facilitate simple and safe removal from the carton(s). Note that different
components may be shipped in separate cartons. This section covers mainly on the RAID and Switch
components.
1.2.1 What Is In Your Order
Depending on your own situation, you most likely fall into one of the scenarios below. Your ExaSAN
distributor should have helped you assess, identify, and order all necessary system components and
accessories.
1. You ordered the complete system solution. In this case, you should have ordered everything described
in Section 1.3.
2. You already have one or more ExaSAN RAID disk systems. In this case, you should only have
ordered everything listed in Sections 1.3.2 and 1.3.3. However, note that the integration of earlier
ExaSAN RAID systems with the SW04/08 switch requires assistance from Accusys Technical
Support.
Note that there are generic system components and accessories required by the ExaSAN solution
architecture, but they are not sold by your ExaSAN distributor and therefore not included in your
ExaSAN Compact order. Please refer to Section 1.5, “What Else You Need” for additional information.
1.2.2 Checking the Equipment You’ll Need
Section 1.1.3 has a complete list of all the equipment you’ll need to set up the ExaSAN Compact system.
Check carefully against that list; verify that you have all of the system components and accessories before
commencing hardware installation.
1.2.3 Unpacking
Follow the steps below to open the carton and remove the system from its packaging. Keep in mind that
you should work with a second person if heavy lifting is a concern for you.
1. Read Chapter 2, “Preparing to Install ExaSAN Compact.”
2. Remove any packing material on the outside of the carton.
3. Cut the tape at the top of the carton. If you use a long cutting instrument, exercise care to avoid
damaging the content inside.
4. Open up the top flaps of the carton to reveal the content inside. Remove the protective foam on top of
the system. Carefully remove each item from inside the carton.
1.3 What’s in the Box
Carefully check your carton contents against the included packing list, or the inside flap of the box, and
your original purchase order. You should have the items as described in the sections below.
Contact your Accusys Distributor or Accusys Customer Service (see Appendix A “Customer Service and
Technical Support” for more information) to report any missing item.