Accusys ExaSAN SW-08 - Manual (Page 21)

1. Introduction
User Guide Page 1-12
1 QSFP Connector Port
For connection with one of the Host Module
Ports on the switch rear panel.
2
Jumper Switch Pin1
LED Indicator
Solid amber indicates the jumper pin in
question is set to “On” position. In this state,
the card is ready for DAS direct connection
with a PCIe RAID system.
Off (no light at all) indicates the jumper pin
in question is set to “Off” position. In this
state, the HBA card is ready for connection
with the ExaSAN SW04/08 switch. See
Section 3.1.2, “Installing the HBA Card,” for
additional information.
3 Link LED Indicator
Solid green indicates connected PCIe 2.0
link; flashing green indicates connected
PCIe 1.0 link or downgraded speed. Off (no
light) when there is no link or indicates a link
with trouble.
4 Access LED Indicator
Flashing blue while there are data access
activities with the connected device.