Ohaus NBF1A2 Navigator Balances - Manual (Page 25)

25
Procedure
• Press the Mode button.
• Press button until ANIMAL is displayed.
• Press Enter button to continue, LEVEL is displayed.
• Press or button to change sampling level,
0, 1, 2 or 3. 0 level is used for an inactive subject, 3
is used for a very active subject.
• Press Enter button to continue, AUTO is displayed.
• Press or button to select AUTO ON or OFF.
• Press Enter button to continue.
When the AUTO function is set ON, different subjects can
be weighed one after another without pressing any
buttons. When the balance displays READY, simply
place the subject on the pan.
3.7 Animal Weighing
Animal Weighing is enabled only when Animal is turned ON in the Mode menu under Setup. Refer to paragraph
4.7 to enable animal weighing.
Starting Animal Cycle
• Place animal container (if used) on pan.
• Press to tare the container.
• Place subject on pan.
• The animal cycle will automatically start if AUTO was
set to ON.
• Press Enter button to start animal cycle if AUTO was
set to OFF.
During Animal Cycle
• Display shows countdown ending with AW 0, then
displays the subjects weight.
Completed Animal Cycle
• Balance displays weight until subject is removed from
the pan.