Ohaus NBF1A2 Navigator Balances - Manual (Page 80)

17
TM
®
Print
Mode
Setup
Units
TM
Enter
On/Off
G/N/T
Zero Tare
4.2 Readout
The Readout menu is used to adapt the balance to environmental conditions. It contains two menus: Filter, Lock
and Exit. Lock, when set ON, locks the Readout settings entered, providing the Lock switch underneath the balance
is also set ON.
Procedure
To select any of the items in the Readout menu, proceed
as follows:
Filter
Filter compensates for vibration or excessive air currents. Default setting is shown bolded.
-0- minimum filtering, fastest stabilization time
-1-
reduced filtering, fast stabilization time
-2- normal filtering, normal stabilization time.
-3- maximum filtering, slowest stabilization time.
• Press the Setup button, CAL is displayed.
• Press button until READOT is displayed.
• Press Enter button to continue, FILTER is displayed.
• Press or button until either FILTER, LOCK
or EXIT is displayed.
• Press Enter button to continue.
• Press or button and select the desired
menu setting. Review settings available below.
• Press Enter button, SAVED is displayed.
• Press or button to continue to LOCK and
EXIT.
• Press Enter button to continue.
Lock
Lock ON/OFF can only be changed when the hardware Lock Switch is set OFF/disabled. A menu is locked when the
menu lock is set ON and the Lock switch is ON. Lock, when selected and turned on, locks all of the entries made
under the Readout menu. In the locked condition, items may be looked at but not changed in the menu. When set
OFF, entries may be changed. OFF is the default setting. Refer to paragraph 4.11 for Menu Lock-Out Protection.
Setup
Use keys to change, press Enter
Change