Ohaus NBF1A2 Navigator Balances - Manual (Page 64)

1
TM
®
Print
Mode
Setup
Units
TM
Enter
On/Off
G/N/T
Zero Tare
OVERVIEW OF CONTROLS
1
3
4
2
5
6
8
9
10
7
No. Designation Function
1 I On/Off button Power on/off button.
2 Mode button Selects standard weighing, percent, parts counting, and checkweighing modes.
3 Units button Selects weighing units.
4 Setup button Selects various menus: calibration, date, time, readout, GLP data, GLP set, print,
RS232, mode, units, global, custom and auto shut-off.
5 Tare button When pressed, performs tare function. When pressed again, clears tare.
6 button When pressed, travels up through menus.
7 button When pressed, travels to the left through menus.
8 button When pressed, travels to the right through menus.
9 G/N/T button When pressed during setup, travels down through the menus.
When pressed following Tare entry, alternates through Gross, Net and Tare weight on
the display and operates in the normal weigh mode.
10 Enter/Print button When in menus, selects item on display, otherwise prints data.
11 Leveling indicator Indicates leveling position of the balance.
12 Zero button When pressed, zero's the display. (Non functional when Tare is activated.)
1
11
®
Print
Mode
Setup
Units
Enter
Stable Center of Zero
g
On/Off
TM
G/N/T
Zero
Tare
B/G
12
Stable Mode Units Setup
Custom
Use keys to change,
B/G
NET Center
of Zero
PC GN
l bo zcti
press Enter
mg k g
Change
%dwt