Ohaus NBF1A2 Navigator Balances - Manual (Page 69)

6
TM
RS232
Power ON/OFF (Battery mode only)
Baud
300, 1200, 2400, 4800, 9600
Parity None, -E-, -Odd-, -0-, -1-
Data
7,8
Stop 1, 2
Lock ON/OFF
Exit
MODE
Weigh ON/OFF
Percent ON/OFF
Count ON/OFF
Checkweigh ON/OFF
Exit
PRINT
Auto Print OFF, Cont, Inter, On Stb
Interval Enter 1 seconds
Stable ON/OFF
Numeric ON/OFF
GLP Con ON/OFF
GLP Tar ON/OFF
Reference ON/OFF
Lock
ON/OFF
Exit
START
DATE
Type m/d/y, dMy, yMd, Myd,ydM,
or dyM
Set
Exit
TIME
Type 12 Hour/24 Hour
Set Time
Adjust Enter xx seconds
Exit
GLP DATA
User Number Enter 6 digits
Project Number Enter 6 digits
Lock ON/OFF
Exit
GLP SET
Time ON/OFF
Balance ID ON/OFF
User Number ON/OFF
Project Number ON/OFF
Difference ON/OFF
Name ON/OFF
Lock ON/OFF
Exit
SETUP SUBMENUS
3 OPERATING YOUR BALANCE
3.1 The Menu (Basic Settings of the Instrument)
The balance has three basic menus; each is selected by front panel buttons marked Mode, Units and Setup.
Mode Button
The Mode button, when pressed, permits the selection of four weighing modes which are: weigh, percent, count and
checkweigh. These modes are controlled by an on or off selection made in the Setup menu under the Mode menu.
Units Button
The Units button, when pressed, allows you to select or change units.
Setup Button
The Setup button, when pressed, allows entry into menus which allow you to set the balance for specific operating
parameters. Each of the menus contain settings which are user selectable. The tables below illustrates the various
menus and the functions which are selectable. The items shown on the menu, which are bolded, are the factory
default settings. If the Setup menu is not entered, the balance would function in the basic manner shown by the
various settings which are bolded. The setup menus shown below are arranged in the order as displayed in the
balance.
UNITS
Units (see paragraph 4.8 for ON/
OFF settings)
Exit
GLOBAL
List NO/YES
Reset NO/YES
Version Software No.
Exit
READOUT
Filter -0-, -1-, -2-, -3-
Lock ON/OFF
Exit
CAL (CALIBRATION)
Span Calibration
Linearity Calibration
Exit
AUTO SHUT OFF
Timer 0 - 60 minutes
Lock ON/OFF
Exit