SENA Parani-BCD110V3 - Manual (Page 19)

Sena Technologies, Inc 19
address of the Bluetooth device which is connected for the last time at specific S-registers
such as ATS46, ATS54, ATS55, ATS56, ATS57, ATS58, ATS59 in SPP profile and ATS72
in I/O profile. Without direct connection to the target device in Mode0, it is possible to
change to Mode1 by setting the S-register for the last connected device with AT
command.
When Parani-BCD110V3 is initially used or hardware reset is committed, there is no BD
address stored in Parani-BCD110V3. In this case, it is impossible for Mode1 to work
properly, so the mode change to Mode1 cannot be made.
Parani-BCD110V3 in Mode1 cannot be discovered or connected by other Bluetooth
devices.
Mode2 Parani-BCD110V3 waits for a connection from the last connected Bluetooth device.
Parani-BCD110V3 in Mode2 is to be a slave and waits for the connection only from the
last connected Bluetooth device in SPP and I/O profile. It also waits for the SCO
connection after SPP connection is established with SCO Enable (ATS84) enabled.
If the last connected Bluetooth device in SPP profile is different from the last connected
Bluetooth device in I/O profile, Parani-BCD110V3 waits for connection from not the latter
but the former in both SPP and I/O profile.
Mode2 is available only in single connection mode. Once Parani-BCD110V3 successfully
connects to the target device in Mode0, it is possible to change the operation mode to
Mode2 from Mode0. Without direct connection to the target device in Mode0, it is possible
to change to Mode2 by setting the S-register for the last connected device with AT
command.
When Parani-BCD110V3 is initially used or hardware reset is committed, there is no BD
address stored in Parani-BCD110V3. In this case, it is impossible for Mode2 to work
properly, so the mode change to Mode 2 cannot be made.
Parani-BCD110V3 in Mode2 cannot be discovered by any other Bluetooth device nor
connected to Bluetooth devices other than the last connected device whose BD address
is stored at specific S-registers such as ATS46 in SPP and ATS72 in I/O profile.
Mode3 Parani-BCD110V3 waits for the connection from any other Bluetooth devices. In Mode 3
the Parani-BCD110V3 is discoverable and can be connected to by other Bluetooth
devices.
Running ParaniWin, the Serial Port Setting window appears as below:
Figure 3-1 Serial Port Setting