SENA Parani-BCD110V3 - Manual (Page 71)

Sena Technologies, Inc 71
C.5. S10: Enable Response Message (default 1)
S10=0, Parani-BCD110V3 does not send response messages to the host system.
S10=1, Parani-BCD110V3 sends response messages to host system.
This value decides whether Parani-BCD110V3 sends response messages such as OK, ERROR,
CONNECT, DISCONNECT or not. When this value is 0, Parani-BCD110V3 will not send any
response messages. If the response messages conflicts with your host programs or devices that
is connected to PParani-BCD110V3, change this value to 0.
C.6. S11: Enable Escape (default 1)
S11=0, Parani-BCD110V3 does not allow escape sequence characters. The operation status of
Connect cannot be changed to Standby. Since the Parani-BCD110V3 skips the process of
detecting escape sequence characters, more efficient data transmission can be had.
S11=1, Parani-BCD110V3 allows for the escape sequence character. Whenever it is needed, the
Connect status can be changed to Standby.
C.7. S12: Clear Data Buffer When Disconnected (default 1)
S12=0, Parani-BCD110V3 does not clear the data buffer received from host system when
disconnected.
S12=1, Parani-BCD110V3 clears the data buffer when disconnected.
C.8. S13: Enable DCD Signal (default 1)
S13=0, DCD signal off
S13=1, DCD signal on
C.9. S14: Enable DTR Transfer (default 1)
S14=0, DTR/DSR signal is transferred in a loop-back fashion.
S14=1, DTR signal is transferred to DSR of remote device.
C.10. S15: Enable Disconnect by DTR (default 0)
S15=0, DTR signal cannot release the connection.
S15=1, The Bluetooth connection can be released when DTR signal is off.
This value decides whether Bluetooth connection is released when DTR signal drops or not. If this
value is 1, you can use DTR signal in order to disconnect Bluetooth connection.