SENA Parani-BCD110V3 - Manual (Page 25)

Sena Technologies, Inc 25
use this menu, please do the following:
Step 1. Connect BCD1 and then push the [START] button after setting up Master configuration.
Step 2. Disconnect BCD1, connect BCD2 and then push the [Next] button after setting up Slave
configuration.
Step 3. Disconnect BCD2, once again connect the BCD1 and then push the Finish button. The
pairing configuration should be completed. At this point, when both Parani-BCD110V3s are
restarted, the connection will be established automatically.
* Note: It is impossible to configure the S-Register and I/O operation. It can be done by AT
commands through Terminal program.
3.6.2. ParaniUpdater
Parani-BCD110V3 supports firmware updates. You can download new firmware images for the
Parani-BCD110V3 at http://www.sena.com. With the ParaniUpdater, you can update the firmware
of Parani-BCD110V3 by selecting the firmware image file and pushing the Start button.
* Note: DO NOT power off Parani-BCD110V3 while the firmware update is progressing. This may
damage the Parani-BCD110V3.
Figure 3-10 ParaniUpdater Window
3.7. Terminal Program
A terminal program is typically an application that will enable a PC to communicate directly with a
modem. If you are using Windows 98SE or higher version of Windows, HyperTerminal program is
included as part of the operating system. Parani-BCD110V3 provides some extended AT
commands for configuration of the Parani-BCD110V3.