SENA Parani-BCD110V3 - Manual (Page 72)

Sena Technologies, Inc 72
C.11. S24: Maximum Number of Inquiry Result (default 15)
The maximum number of inquiry list can be controlled. This value is up to 15.
Because the value 0 means that the maximum number will not be limited, inquiry continues till
inquiry timeout elapses or AT+BTCANCLE is executed to cancel inquiry.
* In case of 0, no limit of inquiry device number may cause the lack of memory and reboot Parani-
BCD110V3.
C.12. S26: Intercharacter Timeout (default 0)
This value describes time interval between characters used to separate the data from serial port.
If there is no more data coming from serial port in this value, data is sent to client.
The unit of this value is msec and the maximum value is 1000msec.
* When 10 bytes data are sent every intercharacter timeout, they are sent separately by 10 bytes
at the optimal value. If the intercharater timeout is set below the optimal value, the data will be
put together and sent by 20, 30, 40 bytes or more.
C.13. S28: Escape Sequence Character (default +)
The decimal number of the ASCII code of escape sequence character can be controlled. The
initial value is 43, the ASCII code of ‘+’.
C.14. S31: Page Timeout (default 20)
This is the timeout in seconds to attempt connection with the ATD command. After this timeout
expired, the Parani-BCD110V3 will reboot in Mode 1 and it will display ‘ERROR’ in the other Mode.
If this value is 0, Parani-BCD110V3 will attempt to connect continuously.
C.15. S33: Inquiry Timeout (default 30)
This is the timeout in seconds to execute inquiry scan. The range is between 0 and 3600. If this
value is 0, Parani-BCD110V3 will execute inquiry scan continuously till the number of inquiry list
exceeds the Maximum Number of Inquiry Result or inquiry scan is canceled by committing
AT+BTCANCEL command.
C.16. S37: Supervision Timeout (default 5)
This is the timeout to presume disconnection, which is set to 5 seconds initially. The smaller the
value becomes, the more quickly Parani-BCD110V3 can detect an abnormal disconnection. But
when the communication is suspended, it may be regarded as disconnection. This value should
be greater than the Slave Disconnect Timeout (S57). (Slave unit depends on the value of master
unit.)