GE Industrial Solutions SG Series 750 T12 UL S2 Installation Guide - Manual (Page 46)

Modifications reserved Page 46/49
OPM_SGS_ISG_M75_M75_2US_V010.doc Installation Guide SG Series 750 UL S2 & SG Series 750 T12 UL S2
4.1.1 Serial Port J3
1 12
13
2
14 3
15 4
16 5
17 6
18 7
19 8
20 9
21 10
22 11
1 14
9
1
J3
SG
S_75
0_Cu
stom
er
inte
rf
ac
e_J
3_
01
2
1
1 1
2 2
3 3
4 4
41
32
41
32
3
2
1
3
2
1
2
11
2
Fig. 4.1.1-1 Serial port J3
Serial port J3 - RS-232 (sub D, female 9 pin) that allows:
Total remote management of the system using software GE Power
Diagnostics, GE Data Protection or GE Service Software for system
protection and management of the UPS systems.
The serial port J3 - RS232 is enabled on
all the units of the parallel system.
Fig. 4.1.1-2 Serial port J3 connection to PC with RS232 1:1 cable DB9m – DB9f
4.1.2 Output free potential contacts
The interface board provides 6 voltage free relay contacts giving some UPS critical alarms and
operation mode.
These signals are available either on connector J2- (sub D, female 25 pin) or terminal blocks X1.
The meaning of the alarms on the free contacts in standard configuration (default) is the following:
X1 / 1, 2, 3 or J2 / 1, 2, 3 (NO, C, NC) Utility Failure
X1 / 4, 5, 6 or J2 / 4, 5, 6 (NO, C, NC) Load on Inverter
X1 / 7, 8, 9 or J2 / 7, 8, 9 (NO, C, NC) Stop Operations
X1 / 12, 13, 14 or J2 / 14, 15, 16 (NO, C, NC) Load on Utility
X1 / 15, 16, 17 or J2 / 17, 18, 19 (NO, C, NC) General Alarm
X1 / 18, 19, 20 or J2 / 20, 21, 22 (NO, C, NC) Acoustic Alarm
In case different alarms or operating status are required, they can be configured on the same terminals
via software from the control panel.
The configuration can be changed in parameters mode by a trained operator using the appropriate
password.
NOTE !
The programmable signals on X1 and J2 will be disabled with Q1 open, with the
exception of the signals for “16 - Manual Bypass ON” and “26 - EPO”.