GE Industrial Solutions AF-300 P11_G11 Ethernet Interface User Manual
User manual, Firmware version 1.xxx
Advertising
Table of contents
Document Outline
- Table of Contents
- About This Manual
- About the OPC-G11S-ETN
- Installation
- Installation and Configuration
- EGD
- Modbus/TCP
- EtherNet/IP
- Appendix A - EGD, EtherNet/IP IO Format
- Appendix B - Drive Parameters
- Parameter List
- Data Format Specification
- Data Format [1]: Integer Data (Positive): Min. Unit 1
- Data Format [2]: Integer Data (Positive, Negative): Min. Unit 1
- Data Format [3]: Decimal Data (Positive): Min. Unit 0.1
- Data Format [4]: Decimal Data (Positive, Negative): Min. Unit 0.1
- Data Format [5]: Decimal Data (Positive): Min. Unit 0.01
- Data Format [6]: Decimal Data (Positive, Negative): Min. Unit 0.01
- Data Format [7]: Decimal Data (Positive): Min. Unit 0.001
- Data Format [8]: Decimal Data (Positive, Negative): Min. Unit 0.001
- Data Format [10]: Alarm Code
- Data Format [11]: Capacity Code
- Data Format [12]: Index Data (ACC/DEC Time, Display Coefficient)
- Data Format [14]: Operation Command
- Data Format [15]: Universal Output Terminal
- Data Format [16]: Operating State
- Data Format [17]: Type Code
- Data Format [18]: Code Setting \(1 – 4 Figures\
- Data Format [19]: Amperage Value Decimal Data (Positive)
- Data Format [20]: Transmission Error Code
- Data Format [21]: Auto Tuning
- Appendix C – Ethernet/IP Objects
- Appendix D - EGD Exchanges