GE Industrial Solutions AF-300 P11_G11 Ethernet Interface - Manual (Page 19)

Installation and Configuration 13
Fault Detection and Action
A network loss event will be generated to the drive from the Ethernet option board when any of the following
events occur:
Event Source Condition Fault cleared when
Link lost Hardware Link was established. Network cable connected
Connection time-out - Connection is deleted or
module receives information
on connection again.
Connection Idle
EtherNet/IP
Configured to set error
on IDLE. See drive
parameter o33. Master is set in run mode
A consumed data exchange
enters the UNHEALTY
state. EGD The configured
consumption time must
not be set to zero. Exchange enters the
HEALTHY state
The time from last
Modbus/TCP message has
exceeded the configured
Modbus time-out action. Modus/TCP Configured Modbus
timeout action must not
be set to zero.
See drive parameter
o34. A new Modbus/TCP
message is received.
After an error is cleared, the error must be acknowledged to the drive before drive control will start again. The
drive’s reaction to a network loss event can be set, see the “Operation Configuration Parameters” section.