GE Industrial Solutions H2007001 G11 Series - Manual (Page 67)

Infinity D Power System Installation Guide: +24V Systems H2007001
Issue 2.0, June 4, 2009 67
Change LAN to Server Mode
To access the controller directly from a PC, you must first change LAN connection to
server mode.
Step Action
1. Press Menu or Accept key,
■
.
2.
Press down arrow, ▼, to Configuration.
3. Press the right arrow key, ► (or square “accept” key,
■
) to advance.
4.
Press down arrow, ▼, to Communications Ports.
5. Press the right arrow key, ► (or square “accept” key,
■
) to advance.
6.
Press down arrow, ▼, to Network Settings.
7. P Press the right arrow key, ► (or square “accept” key,
■
) to advance.
8.
Press down arrow, ▼, to highlight DHCP.
9. Press the right arrow key, ► (or square “accept” key,
■
) to advance.
10. Press down arrow, ▼, to toggle to SERVER.
11. Press save,
■
.
12. Press the Back Arrow, §, to return to the default screen.
13. Wait 2 minutes.
14. Activate changes by removing the latching PWR connection, located on the lower right of the
controller, until the LEDs extinguish.
15.
Reapply power by reinserting the PWR connection until latched.
16.
Verify Server Mode by pressing Menu>Status>Network Settings>Port 1> to find 192.168.2.1 as
the network address.
Warning: It is always safer to leave the controller in Client mode. This avoids LAN
conflicts should the controller ever be connected to a Local Area Network.